개요

• 솔라나라에 설명된 어플리케이션에 대해 맨 페이지를 찾아 출력한다.
• MAN 페이지에 대한 설명은 윈디하나의 솔라나라: MAN 페이지을 참고하자.
• svcadm(1M)을 검색하려면 섹션에서 1M 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.

t_unbind(3c)

Standard C Library Functions                                      t_unbind(3C)



NAME
       t_unbind - disable a transport endpoint

SYNOPSIS
       #include <xti.h>

       int t_unbind(int fd);

DESCRIPTION
       The  This  routine is part of the XTI interfaces which evolved from the
       TLI interfaces. XTI represents the future  evolution  of  these  inter‐
       faces.  However,  TLI  interfaces are supported for compatibility. When
       using a TLI routine that has the same  name  as  an  XTI  routine,  the
       tiuser.h header file must be used. Refer to the TLI  COMPATIBILITY sec‐
       tion for a description of differences between the two interfaces.


       t_unbind() function disables the transport  endpoint  specified  by  fd
       which  was  previously bound by t_bind(3C). On completion of this call,
       no further data or events destined for this transport endpoint will  be
       accepted  by  the  transport provider. An endpoint which is disabled by
       using t_unbind() can be enabled by a subsequent call to t_bind(3C).

RETURN VALUES
       Upon successful completion, a value of  0  is  returned.  Otherwise,  a
       value of -1 is returned and t_errno is set to indicate an error.

VALID STATES
       T_IDLE.

ERRORS
       On failure, t_errno is set to one of the following:

       TBADF        The  specified  file descriptor does not refer to a trans‐
                    port endpoint.


       TLOOK        An asynchronous event has occurred on this transport  end‐
                    point.


       TOUTSTATE    The communications endpoint referenced by fd is not in one
                    of the states in which a call to this function is valid.


       TPROTO       This error indicates that a communication problem has been
                    detected  between XTI and the transport provider for which
                    there is no other suitable XTI error (t_errno).


       TSYSERR      A system error has occurred during execution of this func‐
                    tion.


TLI COMPATIBILITY
       The XTI and TLI interface definitions have common names but use differ‐
       ent header files. This, and other semantic differences between the  two
       interfaces are described in the subsections below.

   Interface Header
       The XTI interfaces use the header file, xti.h  .  TLI interfaces should
       not use this header. They should use the header:
         #include <tiuser.h>

   Error Description Values
       The t_errno value that can be set by the XTI interface  and  cannot  be
       set by the TLI interface is:
         TPROTO

ATTRIBUTES
       See attributes(7) for descriptions of the following attributes:


       tab()  box; cw(2.75i) |cw(2.75i) lw(2.75i) |lw(2.75i) ATTRIBUTE TYPEAT‐
       TRIBUTE VALUE _ MT-LevelMT-Safe


SEE ALSO
       t_bind(3C), attributes(7)



Oracle Solaris 11.4               7 May 1998                      t_unbind(3C)