svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.
udp(4p)
udp(4P) Network Protocols udp(4P)
NAME
udp, UDP - Internet User Datagram Protocol
SYNOPSIS
#include <sys/socket.h>
#include <netinet/in.h>
s = socket(AF_INET, SOCK_DGRAM, 0);
s = socket(AF_INET6, SOCK_DGRAM, 0);
t = t_open("/dev/udp", O_RDWR);
t = t_open("/dev/udp6", O_RDWR);
DESCRIPTION
UDP is a simple datagram protocol which is layered directly above the
Internet Protocol ("IP") or the Internet Protocol Version 6 ("IPv6").
Programs may access UDP using the socket interface, where it supports
the SOCK_DGRAM socket type, or using the Transport Level Interface
("TLI"), where it supports the connectionless (T_CLTS) service type.
Within the socket interface, UDP is normally used with the sendto(),
sendmsg(), recvfrom(), and recvmsg() calls (see send(3C) and recv(3C)).
If the connect(3C) call is used to fix the destination for future pack‐
ets, then the recv(3C) or read(2) and send(3C) or write(2) calls may be
used.
UDP address formats are identical to those used by the Transmission
Control Protocol ("TCP"). Like TCP, UDP uses a port number along with
an IP or IPv6 address to identify the endpoint of communication. The
UDP port number space is separate from the TCP port number space, that
is, a UDP port may not be "connected" to a TCP port. The bind(3C) call
can be used to set the local address and port number of a UDP socket.
The local IP or IPv6 address may be left unspecified in the bind() call
by using the special value INADDR_ANY for IP, or the unspecified ad‐
dress (all zeroes) for IPv6. If the bind() call is not done, a local IP
or IPv6 address and port number will be assigned to the endpoint when
the first packet is sent. Broadcast packets may be sent, assuming the
underlying network supports this, by using a reserved "broadcast ad‐
dress." This address is network interface dependent.
Note that no two UDP sockets can be bound to the same port unless the
bound IP addresses are different. IPv4 INADDR_ANY and IPv6 unspecified
addresses compare as equal to any IPv4 or IPv6 address. For example, if
a socket is bound to INADDR_ANY or unspecified address and port X, no
other socket can bind to port X, regardless of the binding address.
This special consideration of INADDR_ANY and unspecified address can be
changed using the SO_REUSEADDR socket option. If SO_REUSEADDR is set on
a socket doing a bind, IPv4 INADDR_ANY and IPv6 unspecified address do
not compare as equal to any IP address. This means that as long as the
two sockets are not both bound to INADDR_ANY/unspecified address or the
same IP address, the two sockets can be bound to the same port.
If an application does not want to allow another socket using the
SO_REUSEADDR option to bind to a port its socket is bound to, the ap‐
plication can set the socket level option SO_EXCLBIND on a socket. The
option values of 0 and 1 represent enabling and disabling the option,
respectively. Once this option is enabled on a socket, no other socket
can be bound to the same port.
IPv6 does not support broadcast addresses; their function is supported
by IPv6 multicast addresses.
Options at the IP level may be used with UDP. See ip(4P) or ip6(4P).
Additionally, there is one UDP-level option of interest to IPsec Key
Management applications (see ipsec(4P) and pf_key(4P)):
UDP_NAT_T_ENDPOINT
If this boolean option is set, datagrams sent via this socket will
have a non-ESP marker inserted between the UDP header and the data.
Likewise, inbound packets that match the endpoint's local-port will
be demultiplexed between ESP or the endpoint itself if a non-ESP
marker is present. This option is only available on IPv4 sockets
(AF_INET), and the application must have sufficient privilege to
use PF_KEY sockets to also enable this option.
There are a variety of ways that a UDP packet can be lost or corrupted,
including a failure of the underlying communication mechanism. UDP im‐
plements a checksum over the data portion of the packet. If the check‐
sum of a received packet is in error, the packet will be dropped with
no indication given to the user. A queue of received packets is pro‐
vided for each UDP socket. This queue has a limited capacity. Arriving
datagrams which will not fit within its high-water capacity are
silently discarded.
UDP processes Internet Control Message Protocol ("ICMP") and Internet
Control Message Protocol Version 6 ("ICMP6") error messages received in
response to UDP packets it has sent. See icmp(4P) and icmp6(4P).
ICMP "source quench" messages are ignored. ICMP "destination unreach‐
able," "time exceeded" and "parameter problem" messages disconnect the
socket from its peer so that subsequent attempts to send packets using
that socket will return an error. UDP will not guarantee that packets
are delivered in the order they were sent. As well, duplicate packets
may be generated in the communication process.
ICMP6 "destination unreachable" packets are ignored unless the enclosed
code indicates that the port is not in use on the target host, in which
case, the application is notified. ICMP6 "parameter problem" notifica‐
tions are similarly passed upstream. All other ICMP6 messages are ig‐
nored.
SEE ALSO
read(2), write(2), bind(3C), connect(3C), recv(3C), send(3C), icmp(4P),
icmp6(4P), inet(4P), inet6(4P), ip(4P), ip6(4P), ipsec(4P), pf_key(4P),
tcp(4P)
Postel, Jon, RFC 768, User Datagram Protocol, Network Information Cen‐
ter, August 1980. https://tools.ietf.org/html/rfc768.
Huttunen, A., Swander, B., Volpe, V., DiBurro, L., Stenberg, M., RFC
3948, UDP Encapsulation of IPsec ESP Packets, The Internet Society,
2005. https://tools.ietf.org/html/rfc3948.
DIAGNOSTICS
A socket operation may fail if:
EISCONN A connect() operation was attempted on a socket on
which a connect() operation had already been per‐
formed, and the socket could not be successfully dis‐
connected before making the new connection.
EISCONN A sendto() or sendmsg() operation specifying an ad‐
dress to which the message should be sent was at‐
tempted on a socket on which a connect() operation had
already been performed.
ENOTCONN A send() or write() operation, or a sendto() or
sendmsg() operation not specifying an address to which
the message should be sent, was attempted on a socket
on which a connect() operation had not already been
performed.
EADDRINUSE A bind() operation was attempted on a socket with a
network address/port pair that has already been bound
to another socket.
EADDRNOTAVAIL A bind() operation was attempted on a socket with a
network address for which no network interface exists.
EINVAL A sendmsg() operation with a non-NULL msg_accrights
was attempted.
EACCES A bind() operation was attempted with a "reserved"
port number and the effective user ID of the process
was not the privileged user.
ENOBUFS The system ran out of memory for internal data struc‐
tures.
Oracle Solaris 11.4 3 Nov 2021 udp(4P)