svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.
routing(4p)
routing(4P) Network Protocols routing(4P)
NAME
routing - system support for packet network routing
DESCRIPTION
The network facilities provide general packet routing. The routing in‐
terface described here can be used to maintain the system's IPv4 rout‐
ing table. It has been maintained for compatibility with older applica‐
tions. The recommended interface for maintaining the system's routing
tables is the routing socket, described at route(4P). The routing
socket can be used to manipulate both the IPv4 and IPv6 routing tables
of the system. Routing table maintenance may be implemented in applica‐
tions processes.
A simple set of data structures compose a "routing table" used in se‐
lecting the appropriate network interface when transmitting packets.
This table contains a single entry for each route to a specific network
or host. The routing table was designed to support routing for the In‐
ternet Protocol (IP), but its implementation is protocol independent
and thus it may serve other protocols as well. User programs may manip‐
ulate this data base with the aid of two ioctl(2) commands, SIOCADDRT
and SIOCDELRT. These commands allow the addition and deletion of a sin‐
gle routing table entry, respectively. Routing table manipulations may
only be carried out by privileged user.
A routing table entry has the following form, as defined in /usr/in‐
clude/net/route.h:
struct rtentry {
unit_t rt_hash; /* to speed lookups */
struct sockaddr rt_dst; /* key */
struct sockaddr rt_gateway; /* value */
short rt_flags; /* up/down?, host/net */
short rt_refcnt; /* # held references */
unit_t rt_use; /* raw # packets forwarded */
/*
* The kernel does not use this field, and without it the structure is
* datamodel independent.
*/
#if !defined(_KERNEL)
struct ifnet *rt_ifp; /* the answer: interface to use */
#endif /* !defined(_KERNEL) */
};
with rt_flags defined from:
#define RTF_UP 0x1 /* route usable */
#define RTF_GATEWAY 0x2 /* destination is a gateway */
#define RTF_HOST 0x4 /* host entry (net otherwise) */
There are three types of routing table entries: those for a specific
host, those for all hosts on a specific network, and those for any des‐
tination not matched by entries of the first two types, called a wild‐
card route. Each network interface installs a routing table entry when
it is initialized. Normally the interface specifies if the route
through it is a "direct" connection to the destination host or network.
If the route is direct, the transport layer of a protocol family usu‐
ally requests the packet be sent to the same host specified in the
packet. Otherwise, the interface may be requested to address the packet
to an entity different from the eventual recipient; essentially, the
packet is forwarded.
Routing table entries installed by a user process may not specify the
hash, reference count, use, or interface fields; these are filled in by
the routing routines. If a route is in use when it is deleted, meaning
its rt_refcnt is non-zero, the resources associated with it will not be
reclaimed until all references to it are removed.
User processes read the routing tables through the /dev/ip device.
The rt_use field contains the number of packets sent along the route.
This value is used to select among multiple routes to the same destina‐
tion. When multiple routes to the same destination exist, the least
used route is selected.
A wildcard routing entry is specified with a zero destination address
value. Wildcard routes are used only when the system fails to find a
route to the destination host and network. The combination of wildcard
routes and routing redirects can provide an economical mechanism for
routing traffic.
ERRORS
EEXIST A request was made to duplicate an existing entry.
ESRCH A request was made to delete a non-existent entry.
ENOBUFS Insufficient resources were available to install a new
route.
ENOMEM Insufficient resources were available to install a new
route.
ENETUNREACH The gateway is not directly reachable. For example, it
does not match the destination/subnet on any of the net‐
work interfaces.
FILES
/dev/ip IP device driver
SEE ALSO
ioctl(2), route(4P), route(8)
Oracle Solaris 11.4 9 Nov 1999 routing(4P)