svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.
rdate(8)
rdate(8) System Administration Commands rdate(8)
NAME
rdate - set system date from a remote host
SYNOPSIS
rdate hostname
DESCRIPTION
rdate sets the local date and time from the hostname given as an argu‐
ment. You must have the authorization solaris.system.date on the local
system. Typically, rdate is used in a startup script.
rdate requests are responded to by the "time" service on the specified
host. To enable the "time" service, use the following commands:
svcadm enable time:stream
svcadm enable time:dgram
USAGE
The rdate command is IPv6-enabled. For more information, see the
ip6(4P) man page.
The protocol used by rdate represents time as an unsigned 32-bit number
of seconds ranging from January 1, 1900 to February 7, 2036. The rdate
command further restricts this range by not changing the system date to
dates prior to December 13, 1983. Another method of time synchroniza‐
tion must be used for dates past the end of this range.
For most purposes, NTP is strongly recommended over this utility. For
more information, see the ntpdate(8) and ntpd(8) man pages.
ATTRIBUTES
See attributes(7) for descriptions of the following attributes:
tab() box; cw(2.75i) |cw(2.75i) lw(2.75i) |lw(2.75i) ATTRIBUTE TYPEAT‐
TRIBUTE VALUE _ Availabilitynetwork/legacy-remote-bsd-utilities _ In‐
terface StabilityObsolete
SEE ALSO
ip6(4P), inetd.conf(5), attributes(7), in.timed(8), ntpd(8), ntpdate(8)
NOTES
This technology may be removed in a future release of Oracle Solaris.
HISTORY
The rdate command has been present since the initial release of So‐
laris.
Oracle Solaris 11.4 28 Jun 2023 rdate(8)