svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.
pfmod(4m)
pfmod(4M) Streams Modules pfmod(4M)
NAME
pfmod - STREAMS Packet Filter Module
SYNOPSIS
#include <sys/pfmod.h>
ioctl(fd, IPUSH, "pfmod");
DESCRIPTION
pfmod is a STREAMS module that subjects messages arriving on its read
queue to a packet filter and passes only those messages that the filter
accepts on to its upstream neighbor. Such filtering can be very useful
for user-level protocol implementations and for networking monitoring
programs that wish to view only specific types of events.
Read-side Behavior
pfmod applies the current packet filter to all M_DATA and M_PROTO mes‐
sages arriving on its read queue. The module prepares these messages
for examination by first skipping over all leading M_PROTO message
blocks to arrive at the beginning of the message's data portion. If
there is no data portion, pfmod accepts the message and passes it along
to its upstream neighbor. Otherwise, the module ensures that the part
of the message's data that the packet filter might examine lies in con‐
tiguous memory, calling the pullupmsg(9F) utility routine if necessary
to force contiguity. (Note: this action destroys any sharing relation‐
ships that the subject message might have had with other messages.) Fi‐
nally, it applies the packet filter to the message's data, passing the
entire message upstream to the next module if the filter accepts, and
discarding the message otherwise. See PACKET FILTERS below for details
on how the filter works.
If there is no packet filter yet in effect, the module acts as if the
filter exists but does nothing, implying that all incoming messages are
accepted. The pfmod section below describes how to associate a packet
filter with an instance of pfmod.
pfmod passes all other messages through unaltered to its upper neigh‐
bor.
Write-side Behavior
pfmod intercepts M_IOCTL messages for the ioctl described below. The
module passes all other messages through unaltered to its lower neigh‐
bor.
IOCTLS
pfmod responds to the following ioctl.
PFIOCSETF This ioctl directs the module to replace its current
packet filter, if any, with the filter specified by the
struct packetfilt pointer named by its final argument.
This structure is defined in <sys/pfmod.h> as:
struct packetfilt {
uchar_t Pf_Priority; /* priority of filter */
uchar_t Pf_FilterLen; /* length of filter cmd list */
ushort_t Pf_Filter[ENMAXFILTERS]; /* filter command list */
};
The Pf_Priority field is included only for compatibility with other
packet filter implementations and is otherwise ignored. The packet fil‐
ter itself is specified in the Pf_Filter array as a sequence of two-
byte commands, with the Pf_FilterLen field giving the number of com‐
mands in the sequence. This implementation restricts the maximum number
of commands in a filter (ENMAXFILTERS) to 255. The next section de‐
scribes the available commands and their semantics.
PACKET FILTERS
A packet filter consists of the filter command list length (in units of
ushort_ts), and the filter command list itself. (The priority field
mentioned above is ignored in this implementation.) Each filter command
list specifies a sequence of actions that operate on an internal stack
of ushort_ts (shortwords) or an offset register. The offset register is
initially zero. Each shortword of the command list specifies an action
and a binary operator. Using _n_ as shorthand for the next shortword of
the instruction stream and _%oreg_ for the offset register, the list of
actions is:
COMMAND SHORTWORDS ACTION
ENF_PUSHLIT 2 Push _n_ on the stack.
ENF_PUSHZERO 1 Push zero on the stack.
ENF_PUSHONE 1 Push one on the stack.
ENF_PUSHFFFF 1 Push 0xFFFF on the stack.
ENF_PUSHFF00 1 Push 0xFF00 on the stack.
ENF_PUSH00FF 1 Push 0x00FF on the stack.
ENF_LOAD_OFFSET 2 Load _n_ into _%oreg_.
ENF_BRTR 2 Branch forward _n_ shortwords if
the top element of the stack is
non-zero.
ENF_BRFL 2 Branch forward _n_ shortwords if
the top element of the stack is zero.
ENF_POP 1 Pop the top element from the stack.
ENF_PUSHWORD+m 1 Push the value of shortword (_m_ +
_%oreg_) of the packet onto the stack.
The binary operators can be from the set {ENF_EQ, ENF_NEQ, ENF_LT,
ENF_LE, ENF_GT,ENF_GE, ENF_AND, ENF_OR, ENF_XOR} which operate on the
top two elements of the stack and replace them with its result.
When both an action and operator are specified in the same shortword,
the action is performed followed by the operation.
The binary operator can also be from the set {ENF_COR, ENF_CAND,
ENF_CNOR, ENF_CNAND}. These are short-circuit operators, in that they
terminate the execution of the filter immediately if the condition they
are checking for is found, and continue otherwise. All pop two elements
from the stack and compare them for equality; ENF_CAND returns false if
the result is false; ENF_COR returns true if the result is true;
ENF_CNAND returns true if the result is false; ENF_CNOR returns false
if the result is true. Unlike the other binary operators, these four do
not leave a result on the stack, even if they continue.
The short-circuit operators should be used when possible, to reduce the
amount of time spent evaluating filters. When they are used, you should
also arrange the order of the tests so that the filter succeeds or
fails as soon as possible; for example, checking the IP destination
field of a UDP packet is more likely to indicate failure than the
packet type field.
The special action ENF_NOPUSH and the special operator ENF_NOP can be
used to only perform the binary operation or to only push a value on
the stack. Since both are (conveniently) defined to be zero, indicating
only an action actually specifies the action followed by ENF_NOP, and
indicating only an operation actually specifies ENF_NOPUSH followed by
the operation.
After executing the filter command list, a non-zero value (true) left
on top of the stack (or an empty stack) causes the incoming packet to
be accepted and a zero value (false) causes the packet to be rejected.
(If the filter exits as the result of a short-circuit operator, the
top-of-stack value is ignored.) Specifying an undefined operation or
action in the command list or performing an illegal operation or action
(such as pushing a shortword offset past the end of the packet or exe‐
cuting a binary operator with fewer than two shortwords on the stack)
causes a filter to reject the packet.
EXAMPLES
The packet filter module is not dependent on any particular device dri‐
ver or module but is commonly used with datalink drivers such as the
Ethernet driver. If the underlying datalink driver supports the Data
Link Provider Interface (DLPI) message set, the appropriate STREAMS
DLPI messages must be issued to attach the stream to a particular hard‐
ware device and bind a datalink address to the stream before the under‐
lying driver routes received packets upstream. Refer to the DLPI Ver‐
sion 2 specification for details on this interface.
The reverse ARP daemon program can use code similar to the following
fragment to construct a filter that rejects all but RARP packets. That
is, it accepts only packets whose Ethernet type field has the value
ETHERTYPE_REVARP. The filter works whether a VLAN is configured or not.
struct ether_header eh; /* used only for offset values */
struct packetfilt pf;
register ushort_t *fwp = pf.Pf_Filter;
ushort_t offset;
int fd;
/*
* Push packet filter streams module.
*/
if (ioctl(fd, I_PUSH, "pfmod") < 0)
syserr("pfmod");
/*
* Set up filter. Offset is the displacement of the Ethernet
* type field from the beginning of the packet in units of
* ushort_ts.
*/
offset = ((uint_t) &eh.ether_type - (uint_t) &eh.ether_dhost) /
sizeof (us_short);
*fwp++ = ENF_PUSHWORD + offset;
*fwp++ = ENF_PUSHLIT | ENF_EQ;
*fwp++ = htons(ETHERTYPE_VLAN);
*fwp++ = ENF_BRFL | ENF_NOP;
*fwp++ = 3;
*fwp++ = ENF_LOAD_OFFSET | ENF_NOP;
*fwp++ = 2;
*fwp++ = ENF_POP | ENF_NOP;
*fwp++ = ENF_PUSHWORD + offset;
*fwp++ = ENF_PUSHLIT | ENF_EQ;
*fwp++ = htons(ETHERTYPE_REVARP);
pf.Pf_FilterLen = fwp - &pf.PF_Filter[0];
This filter can be abbreviated by taking advantage of the ability to
combine actions and operations:
*fwp++ = ENF_PUSHWORD + offset;
*fwp++ = ENF_PUSHLIT | ENF_EQ;
*fwp++ = htons(ETHERTYPE_REVARP);
*fwp++ = htons(ETHERTYPE_VLAN);
*fwp++ = ENF_BRFL | ENF_NOP;
*fwp++ = 3;
*fwp++ = ENF_LOAD_OFFSET | ENF_NOP;
*fwp++ = 2;
*fwp++ = ENF_POP | ENF_NOP;
*fwp++ = ENF_PUSHWORD + offset;
*fwp++ = ENF_PUSHLIT | ENF_EQ;
*fwp++ = htons(ETHERTYPE_REVARP);
SEE ALSO
bufmod(4M), dlpi(4P), pullupmsg(9F)
Oracle Solaris 11.4 27 May 2010 pfmod(4M)