svcadm(1M)을 검색하려면 섹션에서 1M 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.
zonestatd(8)
System Administration Commands zonestatd(8)
NAME
zonestatd - zones monitoring daemon
SYNOPSIS
/usr/lib/zones/zonestatd
DESCRIPTION
zonestatd is a system daemon that is started during system boot. It
monitors the utilization of system resources by zones, as well as zone
and system configuration information such as psrset psets, pool psets,
and resource control settings.
This daemon is started automatically by the zone management software
and should not be invoked directly. It does not constitute a program‐
ming interface; it is classified as a private interface.
SECURITY
The zonestat service in the global zone must be online for the zonestat
service in each non-global zone (NGZ) to function properly. The zones‐
tat service in each NGZ does not directly read system configuration and
utilization data, but rather reads from the zonestat service on the
global zone. For the solaris-kz brand, the zonestat service is entirely
separate.
ATTRIBUTES
See attributes(7) for descriptions of the following attributes:
tab() box; cw(2.75i) |cw(2.75i) lw(2.75i) |lw(2.75i) ATTRIBUTE TYPEAT‐
TRIBUTE VALUE _ Availabilitysystem/zones _ Interface StabilityPrivate
SEE ALSO
prctl(1), svcs(1), zonestat(1), attributes(7), smf(7), zones(7), acc‐
tadm(8), pooladm(8), poolcfg(8), rcapadm(8), svcadm(8)
NOTES
The zonestat service is managed by the service management facility,
smf(7), under the service identifier:
svc:/system/zones-monitoring:default
Administrative actions on this service, such as enabling, disabling, or
requesting restart, can be performed using svcadm(8). The service's
status can be queried using the svcs(1) command.
The zonestat service has the following SMF configuration property:
config/sample_interval
This property sets the zonestatd sample interval. This is the interval
used by the zones monitoring daemon, zonestatd to sample resource uti‐
lization. This is also the interval used to determine configuration
changes such as processor set changes, resource control changes, and
zone state changes.
The default interval is 5 seconds.
The zonestat service makes use of extended accounting facility. If not
already enabled, it enables the tracking of process accounting
resources, and configures a process accounting file. The zonestat ser‐
vice will roll the process accounting log at its configured interval
(see zonestat(1)).
If extended process accounting is enabled externally, the zonestat ser‐
vice will use the process accounting log as configured. It will not
roll the accounting log, but will operate correctly if the accounting
log is rolled externally.
Oracle Solaris 11.4 13 Aug 2010 zonestatd(8)