개요

• 솔라나라에 설명된 어플리케이션에 대해 맨 페이지를 찾아 출력한다.
• MAN 페이지에 대한 설명은 윈디하나의 솔라나라: MAN 페이지을 참고하자.
• svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.

vpo(4)

VPO(4)                   BSD Kernel Interfaces Manual                   VPO(4)

NAME
     vpo — parallel to SCSI interface driver

SYNOPSIS
     device vpo

     For one or more SCSI busses:
     device scbus

DESCRIPTION
     The vpo driver provide access to parallel port Iomega Zip and Jaz drives.

HARDWARE
     The vpo driver supports the following parallel to SCSI interfaces:

     ·   Adaptec AIC-7110 Parallel to SCSI interface (built-in to Iomega ZIP
         drives)
     ·   Iomega Jaz Traveller interface
     ·   Iomega MatchMaker SCSI interface (built-in to Iomega ZIP+ drives)

USAGE
     The driver should let you use a printer connected to the drive while
     transferring data.

     DOS and FreeBSD file systems are supported.  When mounting a DOS file
     system or formatting a FreeBSD file system, check the slice of the disk
     with the gpart(8) utility.

     In order to unixify a ZIP disk, put the following in /etc/disktab:

     zip|zip 100:\
             :ty=removable:se#512:nc#96:nt#64:ns#32:\
             :pa#196608:oa#0:ba#4096:fa#512:\
             :pb#196608:ob#0:bb#4096:fb#512:\
             :pc#196608:oc#0:bc#4096:fc#512:

     and use bsdlabel(8).

     If you have trouble with your driver, your parallel chipset may not run
     properly at the detected mode (NIBBLE, PS2 or EPP).  Tune the ppc(4)
     bootflags to force other modes.

SEE ALSO
     da(4), lpt(4), ppbus(4), ppc(4), scsi(4)

HISTORY
     The vpo manual page first appeared in FreeBSD 3.0.

AUTHORS
     This manual page was written by Nicolas Souchu.

BUGS
     During boot, the driver first tries to detect a classic ZIP, then a ZIP+.
     The ZIP+ detection is intrusive and may send erroneous characters to your
     printer if the drive is not connected to your parallel port.

BSD                            December 14, 2004                           BSD