개요

• 솔라나라에 설명된 어플리케이션에 대해 맨 페이지를 찾아 출력한다.
• MAN 페이지에 대한 설명은 윈디하나의 솔라나라: MAN 페이지을 참고하자.
• svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.

uvscom(4)

UVSCOM(4)                BSD Kernel Interfaces Manual                UVSCOM(4)

NAME
     uvscom — USB support for SUNTAC Slipper U VS-10U serial adapters driver

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device usb
           device ucom
           device uvscom

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):

           uvscom_load="YES"

HARDWARE
     The uvscom driver supports the following adapters:

     ·   DDI Pocket Air H" C@rd
     ·   DDI Pocket Air H" C@rd 64
     ·   NTT P-in
     ·   NTT P-in m@ster

DESCRIPTION
     The uvscom driver provides support for the SUNTAC Slipper U VS-10U chip.
     Slipper U is a PC Card to USB converter for data communication card
     adapters.

     The device is accessed through the ucom(4) driver which makes it behave
     like a tty(4).

FILES
     /dev/ttyU*       for callin ports
     /dev/ttyU*.init
     /dev/ttyU*.lock  corresponding callin initial-state and lock-state
                      devices

     /dev/cuaU*       for callout ports
     /dev/cuaU*.init
     /dev/cuaU*.lock  corresponding callout initial-state and lock-state
                      devices

SEE ALSO
     tty(4), ucom(4), usb(4)

HISTORY
     The uvscom driver first appeared in FreeBSD and later in NetBSD 1.6.
     This manual page was adopted from NetBSD by Tom Rhodes
     <trhodes@FreeBSD.org> in April 2002.

BSD                             April 26, 2017                             BSD