svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.
ure(4)
URE(4) BSD Kernel Interfaces Manual URE(4)
NAME
ure — RealTek RTL8152/RTL8153 USB to Ethernet controller driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device uhci
device ohci
device usb
device miibus
device uether
device ure
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
if_ure_load="YES"
DESCRIPTION
The ure driver provides support for USB Ethernet adapters based on the
RealTek RealTek RTL8152 and RTL8153 USB Ethernet controllers.
NICs based on the RTL8152 are capable of 10 and 100Mbps speeds. NICs
based on the RTL8153 are capable of 10, 100 and 1000Mbps operation.
The ure driver supports the following media types:
autoselect Enable auto selection of the media type and options. The
user can manually override the auto selected mode by adding
media options to the /etc/rc.conf file.
10baseT/UTP Set 10Mbps operation. The mediaopt option can also be used
to select either full-duplex or half-duplex modes.
100baseTX Set 100Mbps (Fast Ethernet) operation. The mediaopt option
can also be used to select either full-duplex or half-duplex
modes.
1000baseTX Set 1000baseTX operation over twisted pair. The RealTek
gigE chips support 1000Mbps in full-duplex mode only.
The ure driver supports the following media options:
full-duplex Force full duplex operation.
half-duplex Force half duplex operation.
For more information on configuring this device, see ifconfig(8).
DIAGNOSTICS
ure%d: watchdog timeout A packet was queued for transmission and a
transmit command was issued, however the device failed to acknowledge the
transmission before a timeout expired.
SEE ALSO
arp(4), miibus(4), netintro(4), ng_ether(4), ifconfig(8)
AUTHORS
The ure driver was written by Kevin Lo <kevlo@FreeBSD.org>.
BSD October 31, 2016 BSD