svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.
uhso(4)
The module can be loaded at boot time by placing the following
line in uhso_load="YES" The driver provides support for several
HSxPA devices from Option N.V. that are based on their packet in‐
terface. Each device has a set of serial ports and a raw IP
packet interface. The serial ports of the device are accessed
through the driver which makes them behave like devices. The
packet interface is exposed as a network interface. Establishing
a connection on the packet interface is achieved by using the
proprietary AT commands and on any of the available serial ports.
The network interface must be configured manually using the data
obtain from these calls. Each device usually have at least two
or more serial ports, their individual purpose can be identified
through Ports identified as features a normal modem interface
that can be used with PPP. Ports identified as uses a propri‐
etary binary interface used for firmware upgrades, this port does
not have a AT command interface and can not be used to control
the device. Other ports features an AT command interface that
can be used for normal device control. The driver should work
with most devices from Option. The following devices have been
verified to work Option GlobeSurfer iCON 7.2 (new firmware) Op‐
tion GlobeTrotter Max 7.2 (new firmware) Option iCON 225 Option
iCON 452 Option iCON 505 The device features a mass storage de‐
vice referred to as which contains drivers for Microsoft Windows;
this is the default mode for the device. The driver automati‐
cally switches the device from mode to modem mode. This behavior
can be disabled by setting to 0 using Establishing a packet in‐
terface connection using the AT command interface available at
one of the serial ports AT+CGDCONT=1,,"apn.provider" AT_OWAN‐
CALL=1,1,1 OK _OWANCALL=1,1
AT_OWANDATA=1 _OWANDATA: 1, 10.11.12.13, 0.0.0.0, 10.2.3.4,
10.2.3.5, \ 0.0.0.0, 0.0.0.0, 72000 Configuring the in‐
terface ifconfig uhso0 10.11.12.13 up route add default -inter‐
face uhso0 echo "nameserver 10.2.3.4" > /etc/resolv.conf echo
"nameserver 10.2.3.5" >> /etc/resolv.conf The connection can be
terminated with AT_OWANCALL=1,0,1 The driver was written by