개요

• 솔라나라에 설명된 어플리케이션에 대해 맨 페이지를 찾아 출력한다.
• MAN 페이지에 대한 설명은 윈디하나의 솔라나라: MAN 페이지을 참고하자.
• svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.

ubsa(4)

UBSA(4)                  BSD Kernel Interfaces Manual                  UBSA(4)

NAME
     ubsa — USB support for Belkin serial adapters

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device usb
           device ucom
           device ubsa

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):

           ubsa_load="YES"

DESCRIPTION
     The ubsa driver provides support for the USB-to-RS232 Bridge chip used by
     a variety of serial adapters from Belkin and other vendors.

     The device is accessed through the ucom(4) driver which makes it behave
     like a tty(4).

HARDWARE
     The ubsa driver supports the following adapters:

     ·   AnyData ADU-500A EV-DO modem
     ·   AnyData ADU-E100A (no EV-DO mode support)
     ·   Belkin F5U103
     ·   Belkin F5U120
     ·   e-Tek Labs Kwik232
     ·   GoHubs GoCOM232
     ·   Peracom single port serial adapter

FILES
     /dev/ttyU*       for callin ports
     /dev/ttyU*.init
     /dev/ttyU*.lock  corresponding callin initial-state and lock-state
                      devices

     /dev/cuaU*       for callout ports
     /dev/cuaU*.init
     /dev/cuaU*.lock  corresponding callout initial-state and lock-state
                      devices

SEE ALSO
     tty(4), ucom(4), usb(4)

HISTORY
     The ubsa driver appeared in FreeBSD 5.0.  The uplcom(4) manual page was
     adopted from NetBSD by Tom Rhodes <trhodes@FreeBSD.org> in April 2002 and
     modified for the ubsa driver by Alexander Kabaev <kan@FreeBSD.org> in
     October 2002.

AUTHORS
     The ubsa driver was written by Alexander Kabaev <kan@FreeBSD.org>.

BSD                             April 26, 2017                             BSD