svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.
sge(4)
SGE(4) BSD Kernel Interfaces Manual SGE(4)
NAME
sge — Silicon Integrated Systems SiS190/191 Fast/Gigabit Ethernet driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device miibus
device sge
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
if_sge_load="YES"
DESCRIPTION
The sge device driver provides support for SiS190 Fast Ethernet con‐
trollers and SiS191 Fast/Gigabit Ethernet controllers.
All LOMs supported by the sge driver have TCP/UDP/IP checksum offload for
transmit and receive, TCP segmentation offload (TSO), hardware VLAN tag
stripping/insertion features. Due to lack of documentation Wake On Lan
(WOL), Jumbo frame and an interrupt moderation mechanism are not sup‐
ported yet.
The sge driver supports the following media types:
autoselect Enable autoselection of the media type and options. The
user can manually override the autoselected mode by adding
media options to rc.conf(5).
10baseT/UTP Set 10Mbps operation.
100baseTX Set 100Mbps (Fast Ethernet) operation.
1000baseTX Set 1000baseTX operation over twisted pair.
The sge driver supports the following media options:
full-duplex Force full duplex operation.
half-duplex Force half duplex operation.
For more information on configuring this device, see ifconfig(8).
HARDWARE
The sge device driver provides support for the following Ethernet con‐
trollers:
· SiS190 Fast Ethernet controller
· SiS191 Fast/Gigabit Ethernet controller
SEE ALSO
altq(4), arp(4), miibus(4), netintro(4), ng_ether(4), rgephy(4), vlan(4),
ifconfig(8)
HISTORY
The sge driver was written by Alexander Pohoyda
<alexander.pohoyda@gmx.net>. And enhanced by Nikolay Denev
<ndenev@gmail.com>. It first appeared in FreeBSD 8.1.
BSD January 16, 2011 BSD