개요

• 솔라나라에 설명된 어플리케이션에 대해 맨 페이지를 찾아 출력한다.
• MAN 페이지에 대한 설명은 윈디하나의 솔라나라: MAN 페이지을 참고하자.
• svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.

iscsi(4)

ISCSI(4)                 BSD Kernel Interfaces Manual                 ISCSI(4)

NAME
     iscsi — iSCSI initiator

SYNOPSIS
     To compile this driver into the kernel, place the following line in the
     kernel configuration file:

           device iscsi

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):

           iscsi_load="YES"

DESCRIPTION
     The iscsi subsystem provides the kernel component of an iSCSI initiator,
     responsible for implementing the Full Feature Phase of the iSCSI proto‐
     col.  The initiator is the iSCSI client, which connects to an iSCSI tar‐
     get, providing local access to a remote block device.  The userland com‐
     ponent is provided by iscsid(8) and both the kernel and userland are con‐
     figured using iscsictl(8).

SYSCTL VARIABLES
     The following variables are available as both sysctl(8) variables and
     loader(8) tunables:

     kern.iscsi.debug
             Verbosity level for log messages from the iscsi driver.  Set to 0
             to disable logging or 1 to warn about potential problems.  Larger
             values enable debugging output.  Defaults to 1.

     kern.iscsi.ping_timeout
             The number of seconds to wait for the target to respond to a NOP-
             Out PDU.  In the event that there is no response within that time
             the session gets forcibly restarted.  Set to 0 to disable sending
             NOP-Out PDUs.  Defaults to 5.

     kern.iscsi.iscsid_timeout
             The number of seconds to wait for iscsid(8) to establish a ses‐
             sion.  After that time iscsi will abort and retry.  Defaults to
             60.

     kern.iscsi.login_timeout
             The number of seconds to wait for a login attempt to succeed.
             After that time iscsi will abort and retry.  Defaults to 60.

     kern.iscsi.maxtags
             The maximum number of outstanding IO requests.  Defaults to 255.

     kern.iscsi.fail_on_disconnection
             Controls the behavior after an iSCSI connection has been dropped
             due to network problems.  When set to 1, a dropped connection
             causes the iSCSI device nodes to be destroyed.  After reconnect‐
             ing, they will be created again.  By default, the device nodes
             are left intact.  While the connection is down all input/output
             operations are suspended, to be retried after the connection is
             reestablished.

SEE ALSO
     iser(4), iscsi.conf(5), iscsictl(8), iscsid(8)

HISTORY
     The iscsi subsystem first appeared in FreeBSD 10.0.

AUTHORS
     The iscsi subsystem was developed by Edward Tomasz Napierala
     <trasz@FreeBSD.org> under sponsorship from the FreeBSD Foundation.

BSD                              May 28, 2017                              BSD