svcadm(8)을 검색하려면 섹션에서 8 을 선택하고, 맨 페이지 이름에 svcadm을 입력하고 검색을 누른다.
dcons(4)
DCONS(4) BSD Kernel Interfaces Manual DCONS(4)
NAME
dcons — dumb console device driver
SYNOPSIS
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
options GDB
device firewire
device dcons
Alternatively, to load the driver as a module at boot time, place the
following line in your kernel configuration file:
options GDB
and in loader.conf(5):
dcons_load="YES"
DESCRIPTION
The dcons device is a simple console device which just reads from and
writes to an allocated buffer for input and output respectively. It is
of no use by itself and it is supposed that the buffer is accessed via a
bus like firewire(4) or kvm(3) for interaction.
The buffer consists of 4 channels. There are 2 ports, one for the con‐
sole TTY and another is GDB port, then each port has an input channel and
an output channel.
FILES
/dev/dcons
/etc/ttys
EXAMPLES
If you want to run getty(8) on dcons, insert the following line into
ttys(5) and send a HUP signal to init(8) using kill(1).
dcons "/usr/libexec/getty std.9600" vt100 on secure
Once the fwohci(4) device is initialized to allow physical access, the
buffer can be accessed from another host via a firewire(4) bus using the
dconschat(8) application. See dconschat(8) for more details.
If you want to use dcons as a gdb(1) port, add the following line into
loader.conf(5):
dcons_gdb="1"
SEE ALSO
dcons_crom(4), ddb(4), firewire(4), fwohci(4), gdb(4), ttys(5),
conscontrol(8), dconschat(8), fwcontrol(8)
AUTHORS
Hidetoshi Shimokawa <simokawa@FreeBSD.org>
BUGS
This driver is currently under development.
BSD January 26, 2008 BSD